Carson's Gym Hub
← All posts

Leg Extension / Leg Curl Setup: Line Up Your Knees First

Most people sit down on a leg extension or leg curl and just start repping. But there's one setup detail that determines whether the machine actually loads your quads and hamstrings — or just beats up your knees.

Line your knee up with the pivot point

Every leg extension/leg curl has a visible axis of rotation — the pivot the lever arm swings around. Your knee joint needs to sit right on that line. Too far forward or back, and the pad travels on the wrong arc. That's when people feel it in the joint instead of the muscle.

Leg extension setup

  • Slide the seat so your knees line up with the pivot. Your back should stay flat against the pad — if you're sliding forward to reach, the seat's too far back.
  • The shin pad sits on the front of your lower shin, just above the ankle. Not on top of the foot.
  • Keep your hips planted. If your butt lifts off the seat at the top, the weight's too heavy.

Leg curl setup

  • Same knee-to-pivot alignment.
  • The pad goes behind your lower leg, just above the heel.
  • Hinge at the knee only — don't let your hips lift or your back arch to help the weight up.

The mistake I see most

Rushing the setup and chasing weight. A lighter stack with your knees actually on the pivot will build more quad and hamstring than a heavy stack with sloppy alignment. And here's how to get more out of less weight — slow the eccentric down to 3-4 seconds and squeeze hard at the top of every rep. That makes a light weight feel a whole lot heavier. Set it up right, control the tempo, then load it.